Why Choose All Guard Pest Control To Protect Your Home?
Termites cause more damage than fire, storm & tempest, earthquakes and floods
every year. As more than one in three homes in Australia get infested by
termite, it makes sense to choose a reliable termite protection system that is
applied by an accredited, reliable and professional termite protection firm. Our
residual termite treatments are Australian Standard compliant, and are extremely
thorough.
It all starts with an inspection of the home as per Australian Standard 4349.3
by a properly qualified technician to see what the extent of termite activity
and damage is. During the inspection, the design and construction of the
property can be assessed, and a termite protection plan for the individual
property can be prepared.
We will always advise you after we have completed our inspection on what action
to take on "high risk areas" within your property, or even how to protect
your home from high risk areas that are within the boundaries of your
neighbour's property. Termites don't discriminate and don't have any
respect for fencing or boundaries.
Concrete areas can be drilled, but Australian Standard and label compliant
volumes must be achieved to stand any chance of treatment success. With drilled
areas, the labelled volumes are 10 litres of termiticide for each metre drilled.
Drill spacings must be no more than 300mm apart. We prefer to use non-repellent
Termidor for concrete areas treated by a drilling and injection technique.
Rates of application
Registered chemicals shall be diluted to the required label concentration and
then applied to the soil or fill at the prescribed label rates of 5 L/mē for a
horizontal barrier, and at 100L/mē for a vertical barrier. To compensate for
impervious soils such as clay where application of these rates would cause
run-off, concentrations greater than those prescribed may be used, with
correspondingly lower rates of application, e.g. the concentration of chemical
may be doubled and the volume applied halved.
What happens when the soil isn't properly prepared? This can lead to
breaches of the chemical barrier. Termites may enter your property through gaps
in the protected zone and not be affected . Care must be taken to prepare the
soil with consideration of the factors below;
Soil Preparation
To allow the required distribution of the applied chemical, and to permit
percolation into the soil to a sufficient depth to deter termites from breaching
the barrier, the soil shall be prepared as follows:
(a) Removal of contaminants, all timber off-cuts, building debris, removable
formwork and other waste materials shall be
removed from the area to be treated.
(b) Clay soils, sloping sites On clay soils, where penetration is likely to be
slow, and on sloping sites where run-off of the chemical mixture is likely to
occur, the surface of the soil shall be scarified along the contours to form
furrows to a depth of not less then 50mm to 80 mm or a 50 mm minimum layer of
sand shall be used to retain the applied
chemical.
NOTE: all clumps of clay should be broken up or removed from the area.,
some sand should be introduced and mixed with an organic soil mix so that
Termidor crystals may be bonded to the soil. Sometimes it may be best to
cut concrete and replace clay soils with organic soil mixtures rather than drill
concrete and inject termiticide into heavy clay soils.
Horizontal barriers
(a) be a minimum of 150mm wide to a minimum depth of 50mm unless otherwise
specified on the registered label;
(b) abut the substance walls on both sides;
(c) surround all other connections between the building and the soil;
(d) cover all areas of sub floor soil where there is inadequate access (see
Clause 2.5.3 of Australian Standard For Termite Protection) or where there is less than 400mm
clearance:
(e) and be continuous beneath a concrete slab-on-ground or on fill.
Following these recommendations may save your home from becoming a
statistic!